Energy UNITS FOR LIFT TABLE one
General Description
This electrical power unit is developed exclusively for your small lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has become widely employed inside the sector of logistic devices which include minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled by the solenoid valve with all the velocity managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
General Description
This power unit is built exclusively for the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve and the speed managed from the adjustable needle valve. When the lift rises to a large positoin, however the power supply is reduce, the lowering movement is controlled from the manual override function.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This energy unit is built exclusively for that huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and the speed controlled by a pressure compensated movement manage valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This electrical power unit is developed exclusively to the substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as pace managed through the adjustable needle valve. When the lift rises to a substantial positoin, but the energy supply is reduce, the reducing motion is controlled by the manual override perform.
Unique Notes
1. This energy unit is of S3 duty cycle, which may only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic parts concerned ahead of set up of the power unit.
three. Viscosity on the oil shoud be 15~46 cst,which must also be clean and cost-free of impurities.N46 hydraulic oil is encouraged.
4. Oil modifying is required just after the first a hundred operation hours,afterwards when every 3000 hours.
5. The power unit proven is created to be mounted vertically.